Worktop (w = 155 mm) is made of sheet steel with returned edges and metric sizing grid, ground steel round blade, bottom blade not ground, hand pressed, plastic backstop on both sides, maximum cutting height is 0.8 mm for the 507 and 0.6 for the 508
The rotary paper cutting machines 507 and 508 are not designed for professional use; they should be used for cutting paper and paperboard in the private sector.
The worktop of the rotary paper cutting machine consists of painted sheet steel that is mounted on both sides in a plastic retaining fixture. On this retaining fixture a chromed round steel bar or, alternatively, a steel tube is affixed, both of these fixtures serve as the guide for sliding the round blade which, for safety purposes, is covered with a plastic cap. During the cutting action the rotating rolling blade sharpens itself on the lower blade and presses the transparent clamping bar (when the automatic contact pressure feature is included) downwards.
The rotary cutting machine is primarily used to cut small numbers of paper sheets, film or paperboard. They are not intended for use in cutting cardboard. The guide edge of the machine does not go all the way under the clamping bar with the result that pieces that are smaller than around 60 mm can no longer be fed at a right angle.
Taglierina a rullo Dahle 507/508
The 507 model is only temporarily available in black or white. Replacement cutting heads are only available in the standard grey colour.