Hacia arriba
Buscar
      Categorías
      Productos
      Se están encontrando productos ...
      Desgraciadamente la búsqueda de »« no ha tenido resultados.

      Chapas Perforadas De Latón

      Espesor

      Anchura x Longitud

      Tamaño/distribución de agujeros

      Grupo de color

      Aplicación

      Marca

      Precio

      3 Artículo   /   9 Variedades
      Vista
      Clasificación: Relevancia
      • Relevancia
      • Topseller
      • Precio creciente
      • Precio decreciente
      • Chapa de latón, perforación cuadrada, grab. ácido
        4 Variedades
        Chapa de latón, perforación cuadrada, grab. ácido
        de 15,10 €
        Sheet format: 45 x 305 mm, Thickness: th = 0.2 mm
      • Chapa de latón, perforación rectang., grab. ácido
        2 Variedades
        Chapa de latón, perforación rectang., grab. ácido
        de 15,10 €
        Sheet format: 45 x 305 mm, Thickness: th = 0.2 mm
      • Chapa de latón, perforación diagonal, grab. ácido
        3 Variedades
        Chapa de latón, perforación diagonal, grab. ácido
        de 15,10 €
        Sheet format: 45 x 305 mm, Thickness: th = 0.2 mm
      Información sobre Chapas Perforadas De Latón

      Etched metal sheet structures are produced through the action of acid on the metal. The sheet, e.g. brass, is first partially covered in an acid resistant "asphalt varnish" or wax and then dipped in an acid bath which either only burns the surface or burns completely through the metal as required. The acid only dissolves the metal in the areas which are not covered. The phenomenon of "undercutting" occurs in the etching process because the acid not only cuts vertically through the metal but also, as soon as the surface has been seared, horizontally as well and this at the same rate. For this reason, the maximum sheet thickness that can be through-cut when only one side of it is covered in the protective varnish is about 0.3 mm.

      Etched sheets are relatively expensive for three reasons: the process itself is so elaborate; the number of sheets produced is low; the costs of waste disposal for the used chemicals is extremely high. This, however, does not stop most people from using them in high quality (architectural) model making. The brass sheets can be easily soldered, easily cut with a shears or cutter and can be easily bent to precise shapes. In short, they are easy to work with!

      Modulor uses cookies to provide you with the best experience on our website. By continuing to browse the site you are agreeing to our use of cookies.    More information