Foglio PVC rigido per scatola luminosa, trasl.

Attributes: A clear statement concerning the colour of light is always difficult because light exists in conjunction with heat. Not every plastic film is able to withstand the heat produced by certain bulbs. Rosco E-Colour filter films were developed for use in theatre and film work and are therefore capable of colouring a beam of light produced by a powerful spotlight. Exposing the E-Colour filter films to long term UV illumination can produce a mild bleaching of the film.

In order to get an impression of the colour that will be produced using a particular film, the chosen light source should be shined through the relevant colour from the colour samples onto a surface. Just holding the film in front of your eyes and looking into the light will usually give a false impression.

Applications: When constructing a lamp a few points should be observed: the heat that a colour filter must withstand is not just dependent on its separation distance from an incandescent or halogen bulb. Much more important is the ventilation that the lamp allows. In the same way that the classic writing table lamp has a reflector with holes on its top side, a self-made lamp should be so constructed that the rising heat from the light source has an escape route. In this way the lamp produces, as if on its own, a cooling stream of air. A further issue concerning heat: the heat produced by a spotlight with a reflector is usually greater than that from one with a system of lenses because the reflector, in contrast to lenses, also tends to gather heat.

One easy way to make a lamp is to simply wrap colour filter film around a fluorescent tube. The temperature of a fluorescent tube is much lower than that of other illuminants so it is OK to just directly wrap the film around the tube. In this case, as also in the case of constructing any lamp with an incandescent or halogen bulb, the best agent for holding the film in place is SCOTCH MAGIC TAPE because it can withstand heat up to 150° C.

Treatment: Colour filter films are very thin which means they can be easily cut using a BLADE or SHEARS. This thinness and lack of strength is a disadvantage when the planned construction requires an inherent stability. This problem can be solved by using perforated sheets, wire mesh or expanded metal as a carrier material allowing for as much open area as possible (a_o). Because of high resistance to heat, POLYCARBONATE or POLYPROPYLENE panels can also be used as long as enough ventilation is provided for in the lamp. Colour filter films can be attached to one another or to other materials with heat-resistant ADHESIVE TAPES, rivets or clamps. Please take into account the different expansion rates for any materials used in a construction that will be exposed to extreme fluctuations of heat. You should resist, for example, gluing a large area of metal with filter film because the resulting stress will quickly fatigue the adherence.

The rigid-PVC translucent light box film has about the same level of translucence as PLEXIGLAS XT-FILM LS. The film spreads the light extremely well and is therefore not only good for making light boxes but also for making lamps or architectural models with lighting effects and for use in simple rear projections. Beyond that, the film is also great for making signs, displays, packing containers, cover sheets, etc.

The material can be printed with special paints using UV-offset printing. It can be folded, grooved, slotted, punched as well as cut with a blade or a shears. In order to prevent the film from taking on a static charge which would attract dust and dirt, the surface can be treated with either AERODECOR ANTISTATIC SPRAY or ANTISTATIC PLASTIC CLEANER.

Plastic films that can be printed with ink-jet and laser printers can be found as INK-JET FILM SHEETS, PLOTTERFILMS, LASER FILMS, COPIER FILMS.